Solar Tracker PDF

Solar Tracker Finished

This is the solar array I built for my parents in Kingman, AZ.  Perhaps the information here will be useful for anyone else looking to embark on a similar project.  There's lots of things I would have done differently and lots of things that could use improvement, but that's how any project goes right? 


The goal was to roughly meet our average energy use of 700kWh/month with a grid-tie system.  There's no point in generating excess, since our utility only applies it as a credit to future bills (and you pay to maintain connection anyways).  I used the data here to predict the ammount of sun we can expect for our area.  Since we'd be tracking on one axis with the second manually adjustable, we can figure on average roughly 9 peak hours of sun per day.  Sun electronics had some nice 200 watt Suntech panels for about $2.10/watt, and we decided to go with 12 of these for a total of 2.4kW.  At 9 peak hours of sun, that gives us around 648kWh per month (not counting line and inverter losses, and heat degradation of the panels).  That seemed to be a fair tradeoff, while maintianing a reasonable size.  Multiple smaller trackers were also considered, but we have some space limitations as far as unshaded area of the yard goes and 2 separate trackers would have been difficult to fit in. 


John Mieding of Mieding & Associates in Bullhead city deserves much of the credit for helping me finalize the CAD drawings into plans and engineering the structure such that it should withstand 90+mph winds that the building codes here require. 


Panels in truck


Sun electronics has a warehouse in Phoenix, so we were able to drive down and pick up the panels to save shipping costs.  These are pretty good sized panels, weighing about 40lbs each.


Back of a panel with diode box


The black box contains three bypass diodes for when the panel is in the nonconducting (in the shade).  Each panel has 8 mounting points, which Suntech recommends you use for windy areas.  The idea was to put bolts through the frame to hold each panel on.  Looking back, I think it would have been better to design around I-beam or U-channel instead of square tubing, but neither were readily available at the time.  Go onto the next page for more construction pics.